Search results
Results From The WOW.Com Content Network
Fault (geology) Satellite image of a fault in the Taklamakan Desert. The two colorful ridges (at bottom left and top right) used to form a single continuous line, but have been split apart by movement along the fault. In geology, a fault is a planar fracture or discontinuity in a volume of rock across which there has been significant ...
A thrust fault is a type of reverse fault, in which the rock above the fault is displaced upwards relative to the rock below the fault. This distinguishes reverse faults from normal faults, where the rock above the fault is displaced downwards, or strike-slip faults, where the rock on one side of the fault is displaced horizontally with respect ...
A thrust fault is a type of reverse fault that has a dip of 45 degrees or less. [1][2] If the angle of the fault plane is lower (often less than 15 degrees from the horizontal [3]) and the displacement of the overlying block is large (often in the kilometer range) the fault is called an overthrust or overthrust fault. [4]
Dip is defined as the angle of the fault relative to the surface of the earth, which indicates the plane on which slip will occur. Lastly, in any non-vertical fault, the block above the fault is called the hanging wall, while the blockbelow the fault is called the footwall. [4] Normal and reverse dip-slip faults with labeled hanging wall and ...
There are three main types of fault, all of which may cause an interplate earthquake: normal, reverse (thrust), and strike-slip. Normal and reverse faulting are examples of dip-slip, where the displacement along the fault is in the direction of dip and where movement on them involves a vertical component. Many earthquakes are caused by movement ...
With crustal extension, a series of normal faults which occur in groups, form in close proximity and dipping in opposite directions. [4] As the crust extends it fractures in series of fault planes, some blocks sink down due to gravity, creating long linear valleys or basins also known as grabens, while the blocks remaining up or uplifted produce mountains or ranges, also known as horsts.
Fault zones with dominantly reverse faulting are known as positive flowers, while those with dominantly normal offsets are known as negative flowers. The identification of such structures, particularly where positive and negative flowers are developed on different segments of the same fault, are regarded as reliable indicators of strike-slip.
The Little River Fault (see the QFFDB, Fault 556) is representative of an extensive zone of faults along the north side of the Olympic Peninsula and in the Strait of Juan de Fuca (likely connected with the fault systems at the south end of Vancouver Island, see fault database map), but these lie west of the crustal blocks that underlie the ...