Ads
related to: can galvanized wire be soldered back to bottom of tube fittings and connection
Search results
Results From The WOW.Com Content Network
Fittings can be made from a large variety of materials. The “AN” standard (for Army/Navy) has been replaced by other military and aerospace standards, though in practice these fittings are still referred to as AN. Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame.
Solder fittings are smooth and easily slip onto the end of a tubing section. The joint is then heated using a torch, and the solder is melted into the connection. When the solder cools, it forms a very strong bond that can last for decades. Solder-connected rigid copper is the most popular choice for water supply lines in modern buildings.
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
The advantages of this method are durability, speed, neatness, and safety. The connection can be made even when the tubing is wet. Crimped fittings are suitable for drinking water pipes and other hot-and-cold systems (including central heating). They are more expensive than sweated fittings.
Looking at the bottom of a socket, or, equivalently, a tube from its bottom, the pins were numbered clockwise, starting at an index notch or gap, a convention that has persisted into the integrated circuit era. In the 1930s, tubes often had the connection to the control grid brought out through a metal top cap on the top of the tube. This was ...
The joint is then heated using a torch, and solder is melted into the connection. When the solder cools, it forms a very strong bond which can last for decades. Solder-connected rigid copper is the most popular choice for water supply lines in modern buildings.
A common example of galvanic corrosion occurs in galvanized iron, a sheet of iron or steel covered with a zinc coating. Even when the protective zinc coating is broken, the underlying steel is not attacked. Instead, the zinc is corroded because it is less "noble". Only after it has been consumed can rusting of the base metal occur.
The main advantages of this technology over traditional soldered copper or glued plastic are that fittings can easily be unmounted and re-used, speed of assembly, assembly is possible when wet, and that the joints can still be rotated after connection. These fittings can be used on all sorts of pipe of many sizes for many purposes.