Ad
related to: stadia leveling rod distance from wall mount house phone with speaker and caller id
Search results
Results From The WOW.Com Content Network
For example, a typical stadia mark pair are set so that the ratio is 100. If one observes a vertical length on a stadia rod, rule or levelling rod with the telescope and sees that the rod spans 0.500 m between the marks (the stadia interval), then the horizontal distance from the instrument to the rod is: 0.500m x 100 = 50 m.
The interval between stadia marks in most surveying instruments is 10 mrad and gives a stadia interval factor of 100. The distance between the instrument and a stadia rod can be determined simply by multiplying the measurement between the stadia hairs (known as the stadia interval) by 100. The instrument must be level for this method to work ...
A level staff, also called levelling rod, is a graduated wooden or aluminium rod, used with a levelling instrument to determine the difference in height between points or heights of points above a vertical datum. When used for stadiametric rangefinding, the level staff is called a stadia rod.
The cross hairs are used to establish the level point on the target, and the stadia allow range-finding; stadia are usually at ratios of 100:1, in which case one metre between the stadia marks on the level staff (or rod) represents 100 metres from the target. The complete unit is normally mounted on a tripod, and the telescope can freely rotate ...
The rod is used in levelling procedures to determine elevations and is read using a level. A Philadelphia rod consists of two sliding sections graduated in hundredths of a foot. On the front of the rod the graduation increasing from zero at the bottom. On the back of the rod the graduation decrease from 13.09 ft at the bottom to 7 ft.
Proper phone etiquette isn’t always obvious and rules can be tricky, so etiquette expert and “Awesome Etiquette” podcast host Lizzie Post provided clear-cut tips for best phone practices ...
The Y level or wye level is the oldest and bulkiest of the older style optical instruments. A low-powered telescope is placed in a pair of clamp mounts, and the instrument then leveled using a spirit level, which is mounted parallel to the main telescope. The term dumpy level (also builder's level) endures despite the evolution in design. They ...
The level must be horizontal to get a valid measurement. Because of this, if the horizontal crosshair of the instrument is lower than the base of the rod, the surveyor will not be able to sight the rod and get a reading. The rod can usually be raised up to 25 feet (7.6 m) high, allowing the level to be set much higher than the base of the rod.