Search results
Results From The WOW.Com Content Network
The Columbia Suicide Severity Rating Scale, or C-SSRS, is a suicidal ideation and behavior rating scale created by researchers at Columbia University, University of Pennsylvania, University of Pittsburgh and New York University to evaluate suicide risk. [1]
graph with an example of steps in a failure mode and effects analysis. Failure mode and effects analysis (FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects.
FMEA is a bottom-up, inductive analytical method which may be performed at either the functional or piece-part level. FMECA extends FMEA by including a criticality analysis, which is used to chart the probability of failure modes against the severity of their consequences. The result highlights failure modes with relatively high probability and ...
The following diagnostic systems and rating scales are used in psychiatry and clinical psychology. This list is by no means exhaustive or complete. For instance, in the category of depression, there are over two dozen depression rating scales that have been developed in the past eighty years.
The Suicide Intent Scale (SIS) was developed in order to assess the severity of suicide attempts. The scale consists of 15 questions which are scaled from 0–2, which take into account both the logistics of the suicide attempt as well as the intent. The scale has high reliability and validity.
The initial FMEDA added additional information to the FMEA process. The first piece of information added in an FMEDA is the quantitative failure data (failure rates and the distribution of failure modes) for all components being analyzed.
The analysis for DRBFM is modeled after a linkage between a good design review and FMEA. A comprehensive, well-done FMEA can be considered one of the inputs (plus many other preparations sheets defined in the methodology) to decide the scope of a DRBFM but an FMEA is not required since the focus is based on the changes and interfaces.
The design or process controls in a FMEA can be used in verifying the root cause and Permanent Corrective Action in an 8D. The FMEA and 8D should reconcile each failure and cause by cross documenting failure modes, problem statements and possible causes. Each FMEA can be used as a database of possible causes of failure as an 8D is developed.