Search results
Results From The WOW.Com Content Network
Isotron is the trade name for a shortwave antenna marketed by Bilal Co. for use as an amateur radio transmitting antenna for restricted spaces. [1] It is physically short as compared to a dipole antenna for a given frequency. It consists of a coil placed between two angled sheet metal plates.
In antenna terms, each of the conductors making up the antenna is known as an element. [9] To calculate the net result, NEC breaks the antenna's elements into a number of sampled points, called segments. It uses simple calculations based on the diameter of the conductor and the wavelength of the signal to determine the induced voltage and ...
A HB9XBG Full Size Vertical Antenna for the 40m-band on Simplon Pass with view to Mount Fletschhorn. The 40-meter or 7-MHz band is an amateur radio frequency band, spanning 7.000-7.300 MHz in ITU Region 2, and 7.000-7.200 MHz in Regions 1 & 3. It is allocated to radio amateurs worldwide on a primary basis; however, only 7.000-7.200 MHz is ...
Antenna directivity is the ratio of maximum radiation intensity (power per unit surface) radiated by the antenna in the maximum direction divided by the intensity radiated by a hypothetical isotropic antenna radiating the same total power as that antenna. For example, a hypothetical antenna which had a radiated pattern of a hemisphere (1/2 ...
Inevitably some antennas won't conveniently fit into any one basic type, so the last section on real antennas is an "everything else" category for a few peculiar antennas that don't fit cleanly into any of the categories or subcategories used in this article; for example, random wire antennas and antennas that are laid down on the ground ...
In most antennas, the radiation from the different parts of the antenna interferes at some angles; the radiation pattern of the antenna can be considered an interference pattern. This results in minimum or zero radiation at certain angles where the radio waves from the different parts arrive out of phase , and local maxima of radiation at other ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
The polar diagrams (and therefore the efficiency and gain) of Yagi antennas are tighter if the antenna is tuned for a narrower frequency range, e.g. the grouped antenna compared to the wideband. Similarly, the polar plots of horizontally polarized yagis are tighter than for those vertically polarized.