When.com Web Search

  1. Ads

    related to: 2014 ram 6.7l exhaust manifold leaking again help my gas powered

Search results

  1. Results From The WOW.Com Content Network
  2. Ford Power Stroke engine - Wikipedia

    en.wikipedia.org/wiki/Ford_Power_Stroke_engine

    The new DPF and active regeneration system greatly hindered fuel economy and the engine was ultimately retired after 2010 and replaced by the 6.7L Power Stroke. While warranty claims began to show a level of unreliability similar to the previous 6.0L Power Stroke, the 6.4L Power Stroke has proved to be capable of handling elevated boost levels ...

  3. Diesel exhaust fluid - Wikipedia

    en.wikipedia.org/wiki/Diesel_exhaust_fluid

    This method may take significant time before the SCR exhaust cleaning system is fully operational, often up to an hour. [4] Another method to thaw DEF (and thus allow for full SCR operation) is to integrate an electric heater into the DEF tank. This heater must be sized, positioned, and powered adequately to rapidly melt sufficient frozen DEF.

  4. Exhaust manifold - Wikipedia

    en.wikipedia.org/wiki/Exhaust_manifold

    In automotive engineering, an exhaust manifold collects the exhaust gases from multiple cylinders into one pipe. The word manifold comes from the Old English word manigfeald (from the Anglo-Saxon manig [many] and feald [fold]) [ 1 ] and refers to the folding together of multiple inputs and outputs (in contrast, an inlet or intake manifold ...

  5. Chrysler Hemi engine - Wikipedia

    en.wikipedia.org/wiki/Chrysler_Hemi_engine

    There were many differences between the racing Hemis and the street version, including but not limited to compression ratio, camshaft, intake manifold, exhaust manifold. Some 1960s NASCAR and NHRA Hemi engines featured magnesium cross-ram intake manifolds and magnesium oil pans in an attempt to reduce the massive weight of the overall engine ...

  6. Exhaust gas recirculation - Wikipedia

    en.wikipedia.org/wiki/Exhaust_gas_recirculation

    Adding exhaust gas therefore reduces pressure and temperature during the isentropic compression in the cylinder, thereby lowering the adiabatic flame temperature. In a typical automotive spark-ignited (SI) engine, 5% to 15% of the exhaust gas is routed back to the intake as EGR. The maximum quantity is limited by the need of the mixture to ...

  7. Cummins B Series engine - Wikipedia

    en.wikipedia.org/wiki/Cummins_B_Series_engine

    The 6.7 ISB had an increase of cylinder bore and piston stroke to 107 mm × 124 mm (4.21 in × 4.88 in), respectively, thereby giving a displacement of 6.7 L; 408.2 cu in (6,690 cc). [11] [full citation needed] With the 6.7 L ISB came the introduction of the Variable Geometry Turbocharger (VGT). The VG Turbocharger was introduced to reduce ...

  8. Exhaust system - Wikipedia

    en.wikipedia.org/wiki/Exhaust_system

    Exhaust system of the Opel Corsa B 1.2 petrol Exhaust manifold (chrome plated) on a car engine. An exhaust system is used to guide reaction exhaust gases away from a controlled combustion inside an engine or stove. The entire system conveys burnt gases from the engine and includes one or more exhaust pipes. Depending on the overall system ...

  9. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...