Ad
related to: osb thickness for exterior walls
Search results
Results From The WOW.Com Content Network
The most common uses are as sheathing in walls, flooring, and roof decking. For exterior wall applications, panels are available with a radiant-barrier layer laminated to one side; this eases installation and increases energy performance of the building envelope. OSB is also used in furniture production.
EPS is the most common of the foams used and has an R-value (thermal resistance) of about 4 °F·ft 2 ·h/Btu (equivalent to about 0.7 K·m 2 /W) per 25 mm thickness, which would give the 3.5 inches (89 mm) of foam in a 4.5-inch-thick (110 mm) panel an R value of 13.8 (caution: extrapolating R-values over thickness may be imprecise due to non ...
Plywood and OSB typically have a density of 560–640 kg/m 3 (35–40 lb/cu ft). For example, 9.5 mm (3 ⁄ 8 in) plywood sheathing or OSB sheathing typically has a surface density of 4.9–5.9 kg/m 2 (1–1.2 lb/sq ft). [51] Many other engineered woods have densities much higher than OSB.
OSSB can replace wood oriented strand board (OSB) and particle board in structural and non-structural applications, such as interior and exterior walls for house construction, furniture and interior decoration.
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
How does OSB differ from chipboard or particle board? osb: thickness:6mm 8mm 9mm 12mm 15mm 18mm 21mm size:1220*2440mm 1250*2500mm glue:MR,WBP,E1,E2 moisture:3-12% density:680-740kg/CBM features of osb 1 tight construction and high strength 2 minimum twisting ,delamination and warping 3 no rotten and decay ,strong against corrosion and fire 4 water proof ,consistent when exposed in the natural ...
Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.
Against exterior exposed foundation walls (should be coated to protect from sunlight). Against exterior walls between foundation and roof, installed between sheathing and siding. Either above or below roof sheathing in a roof assembly. On the exterior side of the studs in a framed wall assembly, or on the exterior side of a mass wall assembly.