When.com Web Search

  1. Ads

    related to: tie rod end purpose

Search results

  1. Results From The WOW.Com Content Network
  2. Tie rod - Wikipedia

    en.wikipedia.org/wiki/Tie_rod

    A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral

  3. Rod end bearing - Wikipedia

    en.wikipedia.org/wiki/Rod_end_bearing

    A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

  4. Ball joint - Wikipedia

    en.wikipedia.org/wiki/Ball_joint

    A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...

  5. Drag link - Wikipedia

    en.wikipedia.org/wiki/Drag_link

    Steering system showing drag link. A drag link converts rotary motion from a crank arm, to a second bellcrank, usually in an automotive steering system.. While the origin of the term is not clear, it pre-dates the automobile, and is described as in use in 1849 as a means of rotating a Ducie cultivator being operated by cable by stationary steam engine (or between engines).

  6. Tie (engineering) - Wikipedia

    en.wikipedia.org/wiki/Tie_(engineering)

    A hurricane tie used to fasten a rafter to a stud. A tie, strap, tie rod, eyebar, guy-wire, suspension cables, or wire ropes, are examples of linear structural components designed to resist tension. [1] It is the opposite of a strut or column, which is designed to resist compression. Ties may be made of any tension resisting material.

  7. Steering linkage - Wikipedia

    en.wikipedia.org/wiki/Steering_linkage

    These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the wheel moves over roads.