Search results
Results From The WOW.Com Content Network
A slide-style DIP switch soldered into a printed circuit board (PCB) Schematic symbol for each individual switch. A DIP switch is a manual electric switch that is packaged with others in a group in a standard dual in-line package (DIP). The term may refer to each individual switch, or to the unit as a whole.
Skinny dual in-line package (SDIP or SPDIP [6]) – Sometimes used to refer to a "narrow" 0.300 in. (or 300 mil) wide DIP, normally when clarification is needed e.g. for DIP with 24 pins or more, which usually come in "wide" 0.600 in wide DIP package. An example of a typical proper full spec for a "narrow" DIP package would be 300 mil body ...
The switches may be arranged so that they are in the same orientation for off, and contrasting orientations for on. [1] A "4-way" (intermediate) switch is a purpose built double pole, double throw (DPDT) switch, internally wired in manufacture to reverse the connections between the input and output and having only four external terminals. This ...
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Simplified single line diagram of a single-phase transfer switch to select either 'city' (utility) power or local generator power 3-phase Intelligent transfer switch. A transfer switch is an electrical switch that switches a load between two sources. Some transfer switches are manual, in that an operator effects the transfer by throwing a ...
The pin assignment of this early series differed from the de facto standard set by the later series in DIP packages (in particular, ground was connected to pin 11 and the power supply to pin 4, compared to pins 7 and 14 for DIP packages). [5] The extremely popular commercial grade plastic DIP (7400N) followed in the third quarter of 1966. [18]
In 1937 W.B. Schulte, [2] McGall's employer, started the company MICRO SWITCH. The company and the Micro Switch trademark have been owned by Honeywell Sensing and Control since 1950. [3] The name has become a generic trademark for any snap-action switch. Companies other than Honeywell now manufacture miniature snap-action switches.
A reed switch has very low resistance when closed, typically as low as 0.05 ohms, whereas the Hall effect sensors can be in the hundreds of ohms. A reed switch requires only two wires whereas most solid-state devices require three wires. A reed switch can be said to require zero power to operate it.