When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Contact resistance - Wikipedia

    en.wikipedia.org/wiki/Contact_resistance

    Contact resistance values are typically small (in the microohm to milliohm range). Contact resistance can cause significant voltage drops and heating in circuits with high current. Because contact resistance adds to the intrinsic resistance of the conductors, it can cause significant measurement errors when exact resistance values are needed.

  3. Voltage drop - Wikipedia

    en.wikipedia.org/wiki/Voltage_drop

    In electronics, voltage drop is the decrease of electric potential along the path of a current flowing in a circuit. Voltage drops in the internal resistance of the source, across conductors, across contacts, and across connectors are undesirable because some of the energy supplied is dissipated.

  4. Copper loss - Wikipedia

    en.wikipedia.org/wiki/Copper_loss

    where I is the current flowing in the conductor and R is the resistance of the conductor. With I in amperes and R in ohms, the calculated power loss is given in watts. Joule heating has a coefficient of performance of 1.0, meaning that every 1 watt of electrical power is converted to 1 Joule of heat. Therefore, the energy lost due to copper ...

  5. Electric power transmission - Wikipedia

    en.wikipedia.org/wiki/Electric_power_transmission

    Electricity is transmitted at high voltages to reduce the energy loss due to resistance that occurs over long distances. Power is usually transmitted through overhead power lines . Underground power transmission has a significantly higher installation cost and greater operational limitations, but lowers maintenance costs.

  6. Reflections of signals on conducting lines - Wikipedia

    en.wikipedia.org/wiki/Reflections_of_signals_on...

    A time-domain reflectometer; an instrument used to locate the position of faults on lines from the time taken for a reflected wave to return from the discontinuity.. A signal travelling along an electrical transmission line will be partly, or wholly, reflected back in the opposite direction when the travelling signal encounters a discontinuity in the characteristic impedance of the line, or if ...

  7. Overhead power line - Wikipedia

    en.wikipedia.org/wiki/Overhead_power_line

    Bundled conductors reduce the voltage gradient in the vicinity of the line. This reduces the possibility of corona discharge. At extra high voltage, the electric field gradient at the surface of a single conductor is high enough to ionize air, which wastes power, generates unwanted audible noise and interferes with communication systems. The ...

  8. Voltage reduction - Wikipedia

    en.wikipedia.org/wiki/Voltage_reduction

    Voltage reduction has become another option for utilities to reduce demand—typically unbeknownst to the customer. However, only the resistive portion of the load responds to the reduction in voltage to reduce aggregate demand. Loads such as incandescent lights and heater coils will use less power as the voltage is lowered.

  9. Skin effect - Wikipedia

    en.wikipedia.org/wiki/Skin_effect

    Skin depth, δ, is defined as the depth where the current density is just 1/e (about 37%) of the value at the surface; it depends on the frequency of the current and the electrical and magnetic properties of the conductor. Induction cookers use stranded coils to reduce heating of the coil itself due to skin effect. The AC frequencies used in ...