Search results
Results From The WOW.Com Content Network
In infrastructure or access point mode, all traffic has to pass through an Access Point (AP). Thus, two stations on the same access point that are communicating with each other must have each and every frame transmitted twice: from the sender to the access point, then from the access point to the receiver.
Wi-Fi positioning system (WPS, WiPS or WFPS) is a geolocation system that uses the characteristics of nearby Wi‑Fi access points to discover where a device is located. [1]It is used where satellite navigation such as GPS is inadequate due to various causes including multipath and signal blockage indoors, or where acquiring a satellite fix would take too long. [2]
NSFNet Internet architecture, c. 1995. Internet exchange points began as Network Access Points or NAPs, a key component of Al Gore's National Information Infrastructure (NII) plan, which defined the transition from the US Government-paid-for NSFNET era (when Internet access was government sponsored and commercial traffic was prohibited) to the commercial Internet of today.
IEEE 802.11ac-2013 or 802.11ac is a wireless networking standard in the IEEE 802.11 set of protocols (which is part of the Wi-Fi networking family), providing high-throughput wireless local area networks (WLANs) on the 5 GHz band.
Wi-Fi client devices typically connect to the access point that can provide the strongest signal within that service set. [109] Increasing the number of Wi-Fi access points for a network provides redundancy, better range, support for fast handover, and increased overall network capacity by using more channels or by defining smaller cells.
It has seen widespread worldwide implementation, particularly within the corporate workspace. While the original amendment is no longer valid, the term "802.11a" is still used by wireless access point (cards and routers) manufacturers to describe interoperability of their systems at 5.8 GHz, 54 Mbit/s (54 x 10 6 bits per second).
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
This is a list of Internet exchange networks by size, measured by peak data rate (), with additional data on location, establishment and average throughput.No Generally only exchanges with more than ten gigabits per second peak throughput have been taken into consideration.