Ad
related to: typical column detail
Search results
Results From The WOW.Com Content Network
A steel column is extended by welding or bolting splice plates on the flanges and webs or walls of the columns to provide a few inches or feet of load transfer from the upper to the lower column section. A timber column is usually extended by the use of a steel tube or wrapped-around sheet-metal plate bolted onto the two connecting timber sections.
A shear wall, in its simplest definition, is a wall where the entire material of the wall is employed in the resistance of both horizontal and vertical loads. A typical example is a brick or cinderblock wall. Since the wall material is used to hold the weight, as the wall expands in size, it must hold considerably more weight.
A typical cross-section of I-beams. There are two standard I-beam forms: Rolled I-beam, formed by hot rolling, cold rolling or extrusion, depending on the material. Plate girder, formed by welding (or occasionally bolting or riveting) plates. I-beams are commonly made of structural steel but may also be formed from aluminium or other materials.
Early Lally columns were made with structural steel, "standard" pipes, with wall thicknesses slightly less than 1/4". Modern Lally columns are typically made with 16 ga. (approx. 0.06") shells. Modern Lallies are therefore much lower in strength than the older ones (typically less than half the strength), and are also much more subject to ...
A reinforced concrete column is a structural member designed to carry compressive loads, composed of concrete with an embedded steel frame to provide reinforcement. For design purposes, the columns are separated into two categories: short columns and slender columns.
The roof of this industrial building is supported by a space frame structure. If a force is applied to the blue node and the red bar were not present, the resultant effect on the structure would depend entirely on the blue node's bending rigidity, i.e. to its resistance (or lack thereof) to bending; however, with the red bar in place, then assuming negligible bending rigidity of the blue node ...
Looking down the central aisle of the Saint Roch Parish Church of Lemery, Batangas, Philippines, the spaces between each set of columns and roof trusses are bays. An interior bay, between the supports of the vaults, in Lyon Cathedral, France. In architecture, a bay is the space between architectural elements, or a recess or compartment.
The Ionic column is always more slender than the Doric; therefore, it always has a base: [5] Ionic columns are eight and nine column-diameters tall, and even more in the Antebellum colonnades of late American Greek Revival plantation houses. [citation needed] Ionic columns are most often fluted. After a little early experimentation, the number ...