Search results
Results From The WOW.Com Content Network
A ground conductor only carries significant current if there is a circuit fault that would otherwise energize exposed conductive parts and present a shock hazard. In that case, circuit protection devices may detect a fault to a grounded metal enclosure and automatically de-energize the circuit, or may provide a warning of a ground fault.
An I–V curve, showing the difference between static resistance (inverse slope of line B) and differential resistance (inverse slope of line C) at a point (A).. The resistance between two terminals of an electrical device or circuit is determined by its current–voltage (I–V) curve (characteristic curve), giving the current through it for any given voltage across it. [18]
Battery-powering one or more of the circuits can avoid a ground loop, because the entire device may be disconnected from mains power. A hazardous technique sometimes used by amateurs is to break the third wire ground conductor P in one of the component's power cords, by removing the ground pin on the plug, or using a cheater plug. This creates ...
The negative impedance converter (NIC) is an active circuit which injects energy into circuits in contrast to an ordinary load that consumes energy from them.This is achieved by adding or subtracting excessive varying voltage in series to the voltage drop across an equivalent positive impedance.
A typical application is a negative impedance converter with voltage inversion (VNIC). [5] It is interesting that the circuit input voltage has the same polarity as the output voltage, although it is applied to the inverting op-amp input; the input source has an opposite polarity to both the circuit input and output voltages.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
Long-distance electromagnetic telegraph systems from 1820 onwards [a] used two or more wires to carry the signal and return currents. It was discovered by German scientist C.A. von Steinheil in 1836–1837, that the ground could be used as the return path to complete the circuit, making the return wire unnecessary. [2]
The circuit consists of a differential negative resistance device such as a Gunn diode or magnetron tube connected to a resonator such as a LC circuit, dielectric resonator, or cavity resonator. To determine the frequency and amplitude of oscillation, the circuit is thought of as divided by a plane (red) into two parts: the negative resistance ...