Search results
Results From The WOW.Com Content Network
External ARTCC subset (block of discrete codes). [3] 7776 Europe The Mode A code 7776 is assigned as a test code by the ORCAM Users Group, specifically for the testing of transponders. [18] 7777 US, Germany, UK, Belgium, Netherlands: Non-discrete code used by fixed test transponders (RABMs) to check correctness of radar stations (BITE). US
A discrete transponder code (often called a squawk code) is assigned by air traffic controllers to identify an aircraft uniquely in a flight information region (FIR). This allows easy identification of aircraft on radar. [6] [7] Codes are made of four octal digits; the dials on a transponder read from zero to seven, inclusive. Four octal digits ...
VFR requires a pilot to be able to see outside the cockpit to control the aircraft's altitude, navigate, and avoid obstacles and other aircraft. [3] Governing agencies establish specific requirements for VFR flight, including minimum visibility, and distance from clouds, to ensure that aircraft operating under VFR are visible from enough distance to ensure safety.
Transponder pulse-code reporting Mode B Transponder code and altitude reporting Mode C Transponder code, altitude, and TCAS reporting MOE maintenance organisation exposition MOPS Minimum Operational Performance Standard MORA Minimum Off Route Altitude MOSArt Modular Open System Architecture MP manifold pressure: MPL multi-crew pilot license: MPU
An equipment code describes the communication (COM), navigation (NAV), approach aids and surveillance transponder equipment on board an aircraft.These alphabetic codes are used on FAA and ICAO flight plan forms to aid flight service station (FSS) personnel in their handling of aircraft.
When the transponder receives an interrogation request, it broadcasts the configured transponder code (or "squawk code"). This is referred to as "Mode 3A" or more commonly, Mode A. A separate type of response called "Ident" can be initiated from the airplane by pressing a button on the transponder control panel.
The flight should climb to and maintain 5000 feet initially, and further clearance to FL330 may be expected (but is not guaranteed) ten minutes after departure. The frequency to which the crew should tune after departure is 124.50 MHz, and the transponder should be set to 6562 before departure. There is no void time in this example.
FATPL - pre-takeoff checks. Fuel, Altimeters, Transponder, Pitot Heat, Landing Light. [2] FREDA - en-route checks; GUMPS - pre-landing checks; HASELL - checks before aerial manoeuvres; IMSAFE - personal wellness checks; OWLS - checks to assess an unprepared surface for a precautionary landing; PARE - spin recovery technique; PAVE - pre-flight ...