Search results
Results From The WOW.Com Content Network
The heat from the welding process and subsequent re-cooling causes this change from the weld interface to the termination of the sensitizing temperature in the base metal. The extent and magnitude of property change depends primarily on the base material, the weld filler metal, and the amount and concentration of heat input by the welding process.
Parts of a fillet weld. There are 5 pieces to each fillet weld known as the root, toe, face, leg and throat. [2] The root of the weld is the part of deepest penetration which is the opposite angle of the hypotenuse. The toes of the weld are essentially the edges or the points of the hypotenuse.
The arrow tip which goes at an angle to the reference line, pointing to the joint to be welded. The tail which goes at the other end of the reference line. The basic welding symbol which goes on the reference line to indicate the shape of the weld such as a fillet or plug. The symbol is placed on the arrow side or other side of the line to ...
Example of a non-filleted pole (left) and a filleted pole (right) It is common to find a fillet where two parts are welded together. In mechanical engineering, a fillet (pronounced / ˈ f ɪ l ɪ t /, like "fill it") is a rounding of an interior or exterior corner of a part.
Welding joint. In metalworking, a welding joint is a point or edge where two or more pieces of metal or plastic are joined together. They are formed by welding two or more workpieces according to a particular geometry. There are five types of joints referred to by the American Welding Society: butt, corner, edge, lap, and tee. These types may ...
Weld mapping is the process of assigning information to a weld repair or joint to enable easy identification of weld processes, production (welders, their qualifications, date welded), quality (visual inspection, NDT, standards and specifications) and traceability (tracking weld joints and welded castings, the origin of weld materials).
The weldability, also known as joinability, [1] of a material refers to its ability to be welded. Many metals and thermoplastics can be welded, but some are easier to weld than others (see Rheological weldability). A material's weldability is used to determine the welding process and to compare the final weld quality to other materials.
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...