Ads
related to: mahogany tongue and groove siding
Search results
Results From The WOW.Com Content Network
According to Mark's Lumber, "Tongue and groove paneling (often abbreviated as T&G) refers to a set of boards in which each board has both a tongue and a groove on opposing sides." The tongue, or ...
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
[citation needed] At 3 ⁄ 8 inch (9.5 mm) thick, mahogany three-ply "wiggle board" or "bendy board" come in 4 by 8 feet (1.2 m × 2.4 m) sheets with a very thin cross-grain central ply and two thicker exterior plies, either long grain on the sheet, or cross grain. Wiggle board is often glued together in two layers once it is formed into the ...
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
Joiners did the finer work of installing trim and paneling. Plank and board are not consistently defined in history. Sometimes these terms are used synonymously. Board means a piece of lumber (timber) 1 ⁄ 2 inch (1.3 cm) to 1.5 inches (3.8 cm) thick and more than 4 inches (10 cm) wide.
39 in (990 mm) wainscoting using 3 in (76 mm) tongue and groove pine boards. Panelling (or paneling in the United States) is a millwork wall covering constructed from rigid or semi-rigid components. [1] These are traditionally interlocking wood, but could be plastic or other materials.
Ad
related to: mahogany tongue and groove siding