When.com Web Search

  1. Ads

    related to: spt 1 wire vs 2 gauge battery cable lugs oreillys 30

Search results

  1. Results From The WOW.Com Content Network
  2. DIN 72552 - Wikipedia

    en.wikipedia.org/wiki/DIN_72552

    30/51 30a from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g

  3. JST connector - Wikipedia

    en.wikipedia.org/wiki/JST_connector

    JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]

  4. NEMA connector - Wikipedia

    en.wikipedia.org/wiki/NEMA_connector

    All NEMA 6 devices are three-wire grounding devices (hot-hot-ground) used for 208 and 240 V circuits and rated for 250 V maximum, with the 6-15, 6-20 and 6-30 being grounding versions of the 2-15, 2-20 and 2-30, respectively.

  5. Portable cord - Wikipedia

    en.wikipedia.org/wiki/Portable_cord

    Although the construction of a portable cord varies depending on the type, a standard cord has at least two stranded copper conductors sized between #18 and #2 American wire gauge (AWG). The copper stranding, insulation, and outer jacket directly influence the physical properties of the cord and its permitted uses. [1] [2] [3]

  6. SAE J1772 - Wikipedia

    en.wikipedia.org/wiki/SAE_J1772

    SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".

  7. DC connector - Wikipedia

    en.wikipedia.org/wiki/DC_connector

    Often pins 1 and 2 will be negative, 3 and 4 positive for a higher current rating. Female connectors are used as supply and male connectors are used on loads. Most battery belts and power supplies output 13.2 V, but equipment can usually handle a range of 11–18 volts to accommodate battery packs of varying voltages and charging while operating.