Ads
related to: xy vise for drill press machine
Search results
Results From The WOW.Com Content Network
The most common use is to support work when it is in a vise or clamped to the machine bed. If a workpiece is too small to be machined in a vise without it being in contact with all three faces of the vice - parallels can be used either side to give clearance from the vise, and to give support from underneath to eliminate the workpiece being ...
Cross vise, which can be adjusted using leadscrews in the X and Y axes; these are useful if many holes need to be drilled in the same workpiece using a drill press. Compare router table. Off-center vise; Angle vise, with two jaws closing against a right angle; Sine vise, which use gauge blocks to set up a highly accurate angle; Rotary vise ...
Column drill press is a common type characterized by the fact that the drill spindle can be moved up and down axially ("along a column"), and has a height-adjustable table, usually adjustable via a rack and pinion. They often used with a vise holding the workpiece, and the vice is again clamped to the table. The vice has to be moved in order to ...
After the Greenfield factory burned down, the company was reorganized as the Millers Falls Manufacturing Co. [1] It merged with Backus Vise Co. in 1872 to form Millers Falls Co.. [ 3 ] In 1931 Millers Falls tools purchased the majority of the shares of Goodell-Pratt tools and merged with that manufacturer in 1932.
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
Drawbar (machine tool) Drawbar force gauge; Drill press; E. Epoxy granite; H. ... X-Y table This page was last edited on 11 February 2018, at 19:38 (UTC). ...