Ads
related to: milling vise for drill press
Search results
Results From The WOW.Com Content Network
Parallels are used when machining with a mill, drill or any other machining operation that requires work to be held in a vise or with clamps - to keep work parallel or raised evenly such as in a milling vise to give adequate height for the cutting tool/spindle to pass over.
Cross vise, which can be adjusted using leadscrews in the X and Y axes; these are useful if many holes need to be drilled in the same workpiece using a drill press. Compare router table. Off-center vise; Angle vise, with two jaws closing against a right angle; Sine vise, which use gauge blocks to set up a highly accurate angle; Rotary vise ...
Column drill press is a common type characterized by the fact that the drill spindle can be moved up and down axially ("along a column"), and has a height-adjustable table, usually adjustable via a rack and pinion. They often used with a vise holding the workpiece, and the vice is again clamped to the table. The vice has to be moved in order to ...
The mill-drill is a close relative of the vertical mill and quite popular in light industry; and with hobbyists. A mill-drill is similar in basic configuration to a very heavy drill press, but equipped with an X-Y table and a much larger column. They also typically use more powerful motors than a comparably sized drill press, most are muti ...
A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely.
Generally, reaming is done using a drill press. However, lathes, machining centers and similar machines can be used as well. The workpiece is firmly held in place by either a vise, chuck or fixture while the reamer advances. [6]