Ads
related to: concrete slab sealers and coatings pictures exterior ceiling systems design
Search results
Results From The WOW.Com Content Network
They require a dry, clean surface during application to gain adhesion. Topical sealers may alter the coefficient of friction which can make substrates slick when wet – a condition that can be remedied by adding anti-skid materials. Life span is generally 1-5 years, although high-end epoxy/urethane systems can last significantly longer.
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
Blocks were adhered to a reinforced concrete slab, unlike Wright's Californian homes, in which ceiling blocks were adhered to wooden slabs. Concrete blocks for the Tonkens House were made as a lightweight cinder block. Because cinder blocks are porous, a sand based sealer was applied to the exterior of the building to waterproof the house. [14]
Concrete normally allows moisture to pass through so a vertical vapor barrier is needed. Barriers may be a coating or membrane applied to the exterior of the concrete. The coating may be asphalt, asphalt emulsion, a thinned asphalt called cutback asphalt, or an elastomer. [9] Membranes are rubberized asphalt or EPDM rubber. Rubberized products ...
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Vapor retarder paints (for the air-tight drywall system, for retrofits where finished walls and ceilings will not be replaced, or for dry basements: can break down over time due to being chemically based). Extruded polystyrene or foil-faced foam board insulation. Exterior grade plywood, 0.70 US perm (40 SI perm).