Ads
related to: best water methanol injection system installation- Potable Water Filtration
Enjoy Smooth and Clean Water
Taste & Feel the Difference
- Water Filter Estimates
View Our Top 5 Filter Deals
Big Brands - Small Prices
- Fast Water Filter Install
Stress-Free Filter Installations
Expert Installers Near You
- Bespoke Water Filters
Save on Your Filtration Install
Don't Compromise on Quality
- Potable Water Filtration
Search results
Results From The WOW.Com Content Network
The BAC One-Eleven airliner also used water injection for its Rolls-Royce Spey turbofan engines. Filling the tanks with jet fuel instead of water led to the Paninternational Flight 112 crash. [7] In 1978, Olympic Airways Flight 411 had to abort and return to its take-off airport due to a failure of the water injection system or its processes. [8]
MW 50 (Methanol-Wasser 50) was a 50-50 mixture of methanol and water (German: Wasser) that was often sprayed into the supercharger of World War II aircraft engines primarily for its anti-detonation effect, allowing the use of increased boost pressures. Secondary effects were cooling of the engine and charge cooling.
GM-1 (Göring Mischung 1) was a system for injecting nitrous oxide into aircraft engines that was used by the Luftwaffe in World War II. This increased the amount of oxygen in the fuel mixture, and thereby improved high-altitude performance. GM-1 was used on several modifications of existing fighter designs to counter the increasing performance ...
Secondary effects were cooling of the engine and charge cooling. Some performance was gained, but at the cost of engine service life. This was replaced by a system that injected fuel instead of MW50, known as C3-injection, and this was used until 1944. The serious fuel shortage in 1944 forced installation of MW50 instead of C3-injection. With ...
From the filters water was routed to the water injection pumps. The three water injection pumps each had a capacity of 221 m 3 /hr with a differential head of 2068.5 metres (209 bar). The pumps discharged to the 3,000 psi manifold and wellheads. The single water injection booster pump (221 m 3 /hr, 1,379 m (139 bar) differential head) took its ...
A mixture of water and methanol with a molar concentration ratio (water:methanol) of 1.0 - 1.5 is pressurized to approximately 20 bar, vaporized and heated to a temperature of 250 - 360 °C. The hydrogen that is created is separated through the use of Pressure swing adsorption or a hydrogen-permeable membrane made of polymer or a palladium alloy.
Ad
related to: best water methanol injection system installation