Ad
related to: what does sata connect to a hard drive called one piece
Search results
Results From The WOW.Com Content Network
An mSATA SSD on top of a 2.5-inch SATA drive. Serial ATA (SATA). The SATA data cable has one data pair for differential transmission of data to the device, and one pair for differential receiving from the device, just like EIA-422. That requires that data be transmitted serially.
A hard disk head and arm on a platter Microphotograph of a hard disk head. The size of the front edge is about 0.3 * 1.2 mm. The functional part of the head is the round, orange structure in the middle. Also note the connection wires bonded to gold-plated pads. Read–write head of a 3 TB hard disk drive manufactured
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Inner view of a 1998 Seagate HDD that used the Parallel ATA interface 2.5-inch SATA drive on top of 3.5-inch SATA drive, showing close-up of (7-pin) data and (15-pin) power connectors. Current hard drives connect to a computer over one of several bus types, including parallel ATA, Serial ATA, SCSI, Serial Attached SCSI (SAS), and Fibre Channel.
The interface is primarily used to connect a video source to a display device such as a computer monitor, though it can also be used to transmit audio, USB, and other forms of data. Unline HDMI, DisplayPort is open source. drive bay A standard-sized area within a computer case for adding hardware (hard drives, CD drives, etc.) to a computer.
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.
Later, the micro-SATA interface made the total length 78.5mm. 1.8-inch drives with ZIF connectors were used in digital audio players, such as the iPod Classic, and subnotebooks. Later 1.8-inch drives were updated with a micro-SATA connector and up to 320GB of storage (Toshiba MK3233GSG).
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]