Ads
related to: hotpoint refrigerator circulating fan fuse
Search results
Results From The WOW.Com Content Network
A thermal fuse protecting the windings of a small motor Thermal fuse works like that: Melt gets too hot, strong spring sinks into melted substance, weak spring opens circuit. (Weak spring sits on ceramic insulator. A thermal fuse is a cutoff which uses a one-time fusible link.
Hotpoint continued as a subsidiary of GEC until 1989, when it was merged into a new division of GEC called General Domestic Appliances (GDA). 50% of GDA was purchased by General Electric (USA), with whom it owned the joint venture. In 1998, the Redring and Xpelair brands also joined GDA, and Hotpoint was categorized as part of GDA Applied Energy.
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
Food in a refrigerator with its door open. A refrigerator, commonly shortened to fridge, is a commercial and home appliance consisting of a thermally insulated compartment and a heat pump (mechanical, electronic or chemical) that transfers heat from its inside to its external environment so that its inside is cooled to a temperature below the room temperature. [1]
Thermodynamic heat pump cycles or refrigeration cycles are the conceptual and mathematical models for heat pump, air conditioning and refrigeration systems. [1] A heat pump is a mechanical system that transmits heat from one location (the "source") at a certain temperature to another location (the "sink" or "heat sink") at a higher temperature. [2]
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).