Ad
related to: refrigeration temperature and pressure chart for r22 water
Search results
Results From The WOW.Com Content Network
Critical temperature in degrees Celsius; Absolute critical pressure in kilopascals; Since over 100,000 refrigerant blends are possible, [2] this list should only have notable refrigerants and refrigerant blends.
R-407A is for use in low- and medium-temp refrigeration. Uses a polyolester (POE) oil. R-407C is for use in air conditioning. Uses a minimum of 20 percent POE oil. R-407F and R-407H are for use in medium- and low-temperature refrigeration applications (supermarkets, cold storage, and process refrigeration); direct expansion system design only.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
A refrigerant needs to have: a boiling point that is somewhat below the target temperature (although boiling point can be adjusted by adjusting the pressure appropriately), a high heat of vaporization, a moderate density in liquid form, a relatively high density in gaseous form (which can also be adjusted by setting pressure appropriately), and ...
At the start of the thermodynamic cycle the refrigerant enters the compressor as a low pressure and low temperature vapor. In heat pumps, this refrigerant is typically R32 refrigerant or R290 refrigerant. Then the pressure is increased and the refrigerant leaves as a higher temperature and higher pressure superheated gas.
From 1930 to 1935, they developed dichlorodifluoromethane (CCl 2 F 2 or R12), trichlorofluoromethane (CCl 3 F or R11), chlorodifluoromethane (CHClF 2 or R22), trichlorotrifluoroethane (CCl 2 FCClF 2 or R113), and dichlorotetrafluoroethane (CClF 2 CClF 2 or R114), through Kinetic Chemicals which was a joint venture between DuPont and General Motors.
The pressure on a pressure-temperature diagram (such as the water phase diagram shown above) is the partial pressure of the substance in question. A phase diagram in physical chemistry , engineering , mineralogy , and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct ...
Dichlorodifluoromethane (R-12 or CFC-12), the most commonly used Freon brand refrigerant prior to its ban in many countries in 1996 and total ban in 2010. 1,1,1,2-Tetrafluoroethane (R-134a or HFC-134a), one of the main replacements for the formerly widespread R-12. Opteon halogenated olefins now replacing Freons in many applications.