Ad
related to: oxy acetylene cutting pressures chart for adults pdf
Search results
Results From The WOW.Com Content Network
MAPP gas can be used at much higher pressures than acetylene, sometimes up to 40 or 50 psi in high-volume oxy-fuel cutting torches which can cut up to 12-inch-thick (300 mm) steel. Other welding gases that develop comparable temperatures need special procedures for safe shipping and handling.
MAPP/oxygen was advantageously used in underwater cutting, which requires high gas pressures (under such pressures acetylene can decompose explosively, making it dangerous to use [5]). However, underwater oxy/fuel gas cutting of any kind has been largely replaced by exothermic cutting [ 6 ] because it cuts more quickly and safely.
Air acetylene welding (321) AAW Chemical welding process, not popular Limited Oxyacetylene welding: 311: OAW Combustion of acetylene with oxygen produces high-temperature flame, inexpensive equipment Maintenance, repair Oxygen/Propane welding 312: Gas welding with oxygen/propane flame Oxyhydrogen welding: 313: OHW
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 31 December 2024. Manufacturing processes This section does not cite any sources.
The justification for using oxy-fuel is to produce a CO 2 rich flue gas ready for sequestration. Oxy-fuel combustion has significant advantages over traditional air-fired plants. Among these are: The mass and volume of the flue gas are reduced by approximately 75%. Because the flue gas volume is reduced, less heat is lost in the flue gas.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A flashback arrestor or flash arrestor is a gas safety device most commonly used in oxy-fuel welding and cutting to stop the flame or reverse flow of gas back up into the equipment or supply line. It protects the user and equipment from damage or explosions.