When.com Web Search

  1. Ads

    related to: well pipe jack

Search results

  1. Results From The WOW.Com Content Network
  2. Pumpjack - Wikipedia

    en.wikipedia.org/wiki/Pumpjack

    The polished rod has a close fit to the stuffing box, letting it move in and out of the tubing without fluid escaping. (The tubing is a pipe that runs to the bottom of the well through which the liquid is produced.) The bridle follows the curve of the horse head as it lowers and raises to create a vertical or nearly-vertical stroke.

  3. Snubbing - Wikipedia

    en.wikipedia.org/wiki/Snubbing

    The first snubbing unit was primarily designed to work in well control situations to "snub" drill pipe and or casing into, or out of, a well bore when conventional well killing methods could not be used. Unlike conventional drilling and completions operations, snubbing can be performed with the well still under pressure (not killed). When done ...

  4. Sucker rod - Wikipedia

    en.wikipedia.org/wiki/Sucker_rod

    The line of sucker rods is represented in this diagram by the solid black line in the center of the well. A sucker rod is a steel rod, typically between 7 and 9 metres (25 and 30 ft) in length, and threaded at both ends, used in the oil industry to join together the surface and downhole components of a reciprocating piston pump installed in an oil well.

  5. Oil well - Wikipedia

    en.wikipedia.org/wiki/Oil_well

    The well is created by drilling a hole 12 cm to 1 meter (5 in to 40 in) in diameter into the earth with a drilling rig that rotates a drill string with a bit attached. At depths during the process, sections of steel pipe , slightly smaller in diameter than the borehole at that point, are placed in the hole. Cement slurry will be pumped down the ...

  6. List of components of oil drilling rigs - Wikipedia

    en.wikipedia.org/wiki/List_of_components_of_oil...

    Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe.

  7. Glossary of oilfield jargon - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_oilfield_jargon

    Bell nipple: An enlarged pipe at the top of a casing string that serves as a funnel to guide drilling tools into the top of the well. Big bear: A big bear is a hitch (see hitch) that lasts a minimum of 50 straight days. Black Leg : Joints of pipe racked back in the derrick. Blowout: A sudden, uncontrolled release of underground pressure from ...