Search results
Results From The WOW.Com Content Network
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.
A dependent suspension normally has a beam (a simple 'cart' axle) or a (driven) live axle that holds wheels parallel to each other and perpendicular to the axle. When the camber of one wheel changes, the camber of the opposite wheel changes in the same way (by convention, on one side, this is a positive change in the camber, and on the other ...
This is an example of a "dead axle". A "live axle" not only connects two wheels, but also drives them. A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have ...
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
Splines on a front drive axle. An axle that is driven by the engine or prime mover is called a drive axle. Modern front-wheel drive cars typically combine the transmission (gearbox and differential) and front axle into a single unit called a transaxle. The drive axle is a split axle with a differential and universal joints between the two half ...
Anti-roll bar (in red) attached to a front axle. The bar must also have its two longitudinal anchor points fastened solidly to transfer forces from side to side. An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps.