Search results
Results From The WOW.Com Content Network
The United States National Electrical Code (NEC) specifies minimum acceptable wiring methods and materials for many states and municipalities. [2] It is sponsored by the National Fire Protection Association (NFPA) and has been periodically revised since 1897. Local jurisdictions usually adopt the NEC or another published code and then ...
United Kingdom: D, M [67] G [68] BS 546 BS 1363 230 V [69] 400 V 50 Hz Type D mostly historical, nowadays used only for remotely switched lighting and similar. Type M historically used in domestic installations, now only for stage lighting (where they are increasingly replaced with Ceeform). Bathrooms may have shaver supply units. United States ...
NEMA 1-15P (two-pole, no ground) and NEMA 5-15P (two-pole with ground pin) plugs are used on common domestic electrical equipment, and NEMA 5-15R is the standard 15-ampere electric receptacle (outlet) found in the United States, and under relevant national standards, in Canada (CSA C22.2 No. 42 [1]), Mexico (NMX-J-163-ANCE) and Japan (JIS C 8303).
In the United States [13] [14] and Canada, [15] national standards specify that the nominal voltage at the source should be 120 V and allow a range of 114 V to 126 V (−5% to +5%). Historically, 110 V, 115 V and 117 V have been used at different times and places in North America.
United States electricity production by type. The United States has the second largest electricity sector in the world, with 4,178 Terawatt-hours of generation in 2023. [2] In 2023 the industry earned $491b in revenue (1.8% of GDP) at an average price of $0.127/kWh.
High-leg delta (also known as wild-leg, stinger leg, bastard leg, high-leg, orange-leg, red-leg, dog-leg delta) is a type of electrical service connection for three-phase electric power installations. It is used when both single and three-phase power is desired to be supplied from a three phase transformer (or transformer bank).
The other end of the three secondary windings and the neutral are brought down the service drop to the service panel. 230 V loads are connected between any of the three-phase wires and the neutral. Because the phases are 120 degrees from each other, the voltage between any two phases is sqrt(3) * 230V = 400V, compared to the 2 * 120V = 240V in ...
In the United States it is not usually used for three phase power but for the high leg delta wiring of split-phase electric power (unknown in Europe). This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase.