Search results
Results From The WOW.Com Content Network
In 1996, light duty vehicles (less than 8,500 lb or 3,900 kg) were the first to be mandated followed by medium duty vehicles (8,500–14,000 lb or 3,900–6,400 kg) in 2005. [1] They are both required to be accessed through a standardized data link connector defined by SAE J1962 .
3/4" 14 TPI ABNT NBR 8614 a ABNT NBR 8614 NPT: 9.5 mm 3/8" No thread ABNT NBR 8614 b ABNT NBR 8614 NPT: 19.1 mm 1.814 mm 3/4" 14 TPI Bayonet Autogas Bayonet No thread Bayonet camping: N/A No thread EXT N/A Butane Canister, 225 g (8 oz) N/A No thread EXT N/A Camping gas VBC02 (G.3) EN 15202 ISO: 16.0 mm 1.5 mm 0.629" 16.93 TPI INT RH
A water in fuel sensor, or WiF sensor, is an electronic sensor used to indicate the presence of water in fuel.It is installed in a fuel filter.When the water level in the water separator reaches the warning level, the WiF sends an electrical signal to the ECU or to dashboard (lamp). [1]
For use in open air applications, where the sensor cannot be mounted to the bottom of the tank or pipe thereof, a special version of the hydrostatic pressure level sensor, a level probe, can be suspended from a cable into the tank to the bottom point that is to be measured. [3] The sensor must be specially designed to seal the electronics from ...
If the car's own vapor recovery system is working properly, then the Stage II nozzle will only be vacuuming normal fresh air and depositing that into the gas station's underground fuel storage tanks. That ends up causing evaporation of fuel vapors into the atmosphere, because too much pressure builds up in those fuel storage tanks.
The term cylinder in this context is sometimes confused with tank, the latter being an open-top or vented container that stores liquids under gravity, though the term scuba tank is commonly used to refer to a compressed gas cylinder used for breathing gas supply to an underwater breathing apparatus.
Simple sight glasses may be just a plastic or glass tube connected to the bottom of the tank at one end and the top of the tank at the other. The level of liquid in the sight glass will be the same as the level of liquid in the tank. Today, however, sophisticated float switches have replaced sight glasses in many such applications.
[3] Where level must be sensed inside a pressurized vessel, often a magnet is used to couple the motion of the float to a switch located outside the pressurized volume. In some cases, a rod through a stuffing box can be used to operate a switch, but this creates high drag and has a potential for leakage. Successful float switch installations ...