Search results
Results From The WOW.Com Content Network
The wire is fed through a guiding tube. Before starting the actual winding process, the wire is mounted to a post or a clamping device of the coil body or winding device. By the linear laying movement of the wire guiding tube, the component to be wound is turned in a way that the wire is distributed throughout the winding space of the coil body.
In some cases the coil is not made of a single wire with multiple turns, and a coil former is not always necessary, but may be constructed in a stack of printed circuit layers. [2] The MLT is an important measure in the design of inductors , transformers and other wound components.
Cause of skin effect. A main current I flowing through a conductor induces a magnetic field H.If the current increases, as in this figure, the resulting increase in H induces separate, circulating eddy currents I W which partially cancel the current flow in the center and reinforce it near the skin.
Small C-frame shaded-pole squirrel-cage motor. With the poles shown, the rotor will rotate in the clockwise direction. Shading coils (copper bars) within the magnetic circuit of the field coil. The shaded-pole motor is the original type of AC single-phase electric motor, dating back to at least as early as 1890. [1]
The structural channel, C-channel or parallel flange channel (PFC), is a type of (usually structural steel) beam, used primarily in building construction and civil engineering. Its cross section consists of a wide "web", usually but not always oriented vertically, and two "flanges" at the top and bottom of the web, only sticking out on one side ...
A growler is an electrical device primarily used for testing a motor for shorted coils. A growler consists of a coil of wire wrapped around an iron core and connected to a source of alternating current. When placed on the armature or stator core of a motor the growler acts as the primary of a transformer and the armature coils act as the ...
Magnetic field (green) created by a current-carrying winding (red) in a typical magnetic core transformer or inductor, with the iron core C forming a closed loop, possibly with air gaps G in it. The drawing shows a section through the core. The purpose of the core is to provide a closed high permeability path for the magnetic field lines.
Metal coil springs are made by winding a wire around a shaped former – a cylinder is used to form cylindrical coil springs. Illustration of various arc springs and arc spring systems (systems consisting of inner and outer arc springs). Coil springs for vehicles are typically made of hardened steel. A machine called an auto-coiler takes spring ...