Search results
Results From The WOW.Com Content Network
A table given a distressed finish, with a historical paint colour, edges that have been sanded down to expose the wood, and vintage hardware attached to the drawers. Distressing (or weathered look ) in the decorative arts is the activity of making a piece of furniture or object appear aged and older, giving it a "weathered look".
Repoussé (French: ⓘ) or repoussage (ⓘ) is a metalworking technique in which a malleable metal is shaped by hammering from the reverse side to create a design in low relief. Chasing (French: ciselure ) or embossing is a similar technique in which the piece is hammered on the front side, sinking the metal.
Furniture repair is the craft of making broken or worn furniture usable again. It may include the preservation of old furniture, which is referred to as restoration . The craft of furniture repair requires a number of different skills including woodworking , metalworking , wood finishing , caning (furniture) , woodturning , and upholstery .
Japanning is a type of finish that originated as a European imitation of East Asian lacquerwork. It was first used on furniture, but was later much used on small items in metal. The word originated in the 17th century. American work, except in the carriage and early automobile industries, is more often called toleware. [1]
In woodworking and the decorative arts, refinishing (also repolishing in the UK)refers to the act of repairing or reapplying the wood finishing on an object. [1] paint, wood finish top coat, [citation needed] wax, lacquer or varnish are commonly used. [2] The artisan or restorer is traditionally aiming for an improved or restored and renewed ...
Finishing the piece will require fine abrasive paper, always backed by a sanding block. Choices of sealers and finishes that can be applied include ordinary varnish, special varnishes, polyurethane (either oil or water based), wax, and French polish. Sand shading is a process used to make a picture appear to be more three-dimensional.
The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.
Tumble finishing, also known as tumbling or rumbling, [1] is a technique for smoothing and polishing a rough surface on relatively small parts. In the field of metalworking , a similar process called barreling , or barrel finishing , [ 2 ] works upon the same principles.