Ad
related to: 83 c10 torque converter lock up solenoid for sale by owner houston tx
Search results
Results From The WOW.Com Content Network
For the 1981 model year, a lock-up torque converter was introduced which coincided with the new EMC control of most GM cars; this version is the THM350-C, which was phased out in 1984 in GM passenger cars for the 700R4. Chevrolet/GMC trucks and vans used the THM350-C until 1986. The lock-up torque converter was unpopular with transmission builders.
Although not strictly a part of classic torque converter design, many automotive converters include a lock-up clutch to improve cruising power transmission efficiency and reduce heat. The application of the clutch locks the turbine to the impeller, causing all power transmission to be mechanical, thus eliminating losses associated with fluid drive.
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Many TCUs now have an input from the vehicle's traction control system. If the TCS detects unfavourable road conditions, a signal is sent to the TCU. The TCU can modify shift programmes by upshifting early, eliminating the torque converter lock-up clutch application, and also eliminating the first gear totally and pulling off in 2nd. [3]
The early model C4 (1964–1969) used a .788-inch 24-spline input shaft, which was upgraded in 1970 to 26-spline and .839-inch. The upgrade also included a matching 26-spline clutch hub. In 1971, Ford went to a 26/24-spline input shaft, meaning the torque-converter side is 26-spline and the clutch hub is 24-spline.
This was a later model of the 125 that debuted for 1982 and included a torque converter clutch or TCC. The TCC acts similar to a clutch in a manual transmission vehicle, in that at speeds above 35 MPH a combination of engine vacuum- and temperature-sensing valves, and a dedicated brake switch - and in later models an ECU - activated a solenoid which engaged a clutch physically locking the ...
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
Two High gave a 0:100 torque split, with Four High yielding a locked 50:50 torque split through direct synchronized gearing. Four Low applied reduction gearing with a 2.61:1 ratio, compared to the previous New Process 205's 1.96:1. The front and rear propeller shafts were locked at all times in Four High and Four Low.