Search results
Results From The WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada [1]. It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples:
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
The Board spent A$5.955 million during its 11 years of operation, and the federal government distributed $10 million to the states to support their conversion process. Between 1984 and 1988, the conversion was the responsibility of the National Standards Commission, later renamed the National Measurement Institute in 1988. The cost of ...
IOW, the "board foot" is not really a unit of volume, it is a way of describing timber by referring to fictional dimensions of the tree the timber came from. Unless there is a corresponding system of nominal volume in the metric system, it is misleading to add "conversions" to lots of sizes in FBM or whatever.
The National Institute of Standards and Technology formerly contended that customary area units are defined in terms of the square survey foot, not the square international foot, [17] but from 2023 it states that "although historically defined using the U.S. survey foot, the statute mile can be defined using either definition of the foot, as is ...
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
The hoppus cubic foot (or ‘hoppus cube’ or ‘h cu ft’) was the standard volume measurement used for timber in the British Empire and countries in the British sphere of influence before the introduction of metric units. It is still used in the hardwood trade in some countries.