When.com Web Search

  1. Ads

    related to: ppm calculation formula in quality control management course pdf full

Search results

  1. Results From The WOW.Com Content Network
  2. Acceptable quality limit - Wikipedia

    en.wikipedia.org/wiki/Acceptable_quality_limit

    Closely related terms are the rejectable quality limit and rejectable quality level (RQL). [1] [2] In a quality control procedure, a process is said to be at an acceptable quality level if the appropriate statistic used to construct a control chart does not fall outside the bounds of the acceptable quality limits. Otherwise, the process is said ...

  3. Threshold limit value - Wikipedia

    en.wikipedia.org/wiki/Threshold_limit_value

    Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.

  4. Parts-per notation - Wikipedia

    en.wikipedia.org/wiki/Parts-per_notation

    At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...

  5. Laboratory quality control - Wikipedia

    en.wikipedia.org/wiki/Laboratory_quality_control

    A control chart is a more specific kind of run chart. The control chart is one of the seven basic tools of quality control, which also include the histogram, pareto chart, check sheet, cause and effect diagram, flowchart and scatter diagram. Control charts prevent unnecessary process adjustments, provide information about process capability ...

  6. Process capability index - Wikipedia

    en.wikipedia.org/wiki/Process_capability_index

    Consider a quality characteristic with target of 100.00 μm and upper and lower specification limits of 106.00 μm and 94.00 μm respectively. If, after carefully monitoring the process for a while, it appears that the process is in control and producing output predictably (as depicted in the run chart below), we can meaningfully estimate its ...

  7. p-chart - Wikipedia

    en.wikipedia.org/wiki/P-chart

    The control limits for this chart type are ¯ ¯ (¯) where ¯ is the estimate of the long-term process mean established during control-chart setup. [ 2 ] : 268 Naturally, if the lower control limit is less than or equal to zero, process observations only need be plotted against the upper control limit.

  8. Useful conversions and formulas for air dispersion modeling

    en.wikipedia.org/wiki/Useful_conversions_and...

    Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude.

  9. Defects per million opportunities - Wikipedia

    en.wikipedia.org/wiki/Defects_per_million...

    A defect can be defined as a nonconformance of a quality characteristic (e.g. strength, width, response time) to its specification. DPMO is stated in opportunities per million units for convenience: processes that are considered highly capable (e.g., processes of Six Sigma quality) are those that experience fewer than 3.4 defects per million ...