When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. FlyTech Dragonfly - Wikipedia

    en.wikipedia.org/wiki/Flytech_Dragonfly

    The four-winged design of the Dragonfly was based on a previous rubber-band-powered ornithopter kit designed by Nathan Chronister and manufactured by The Ornithopter Zone. It also uses the same flapping wing design as the DelFly. The newly available micro-sized motors and batteries developed for cellular telephones made it possible to build an ...

  3. Festo SmartBird - Wikipedia

    en.wikipedia.org/wiki/Festo_SmartBird

    SmartBird is an autonomous ornithopter created by Festo's Bionic Learning Network with an emphasis on better aerodynamics and maneuverability. It is an ornithopter modeled on the herring gull. [1] It has a mass of 450 grams and a wingspan of 1.96 meters. [2] In April 2011 the SmartBird was unveiled at the Hanover Fair.

  4. DelFly - Wikipedia

    en.wikipedia.org/wiki/DelFly

    The result of this exercise was the DelFly I, a 50 cm wingspan, 21 grams flapping wing MAV equipped with a camera. The DelFly I was able to fly both fast and perform slow hovering flight while providing reasonably stable camera images. In 2007, the DelFly II was created: a 28 cm wing span 16 gram flapping wing MAV equipped with onboard camera ...

  5. Entomopter - Wikipedia

    en.wikipedia.org/wiki/Entomopter

    The Earth-bound entomopter has a 15 to 18 cm wing span. A twin set of wings situated fore and aft of the RCM provide balanced resonant flapping to create not only lift and thrust, but full vehicle control. Wing flapping occurs a 35 Hz constant rate. This biologically inspired aerial robot is classified as a micro air vehicle (MAV) because of ...

  6. Ornithopter - Wikipedia

    en.wikipedia.org/wiki/Ornithopter

    An ornithopter (from Greek ornis, ornith-'bird' and pteron 'wing') is an aircraft that flies by flapping its wings. Designers sought to imitate the flapping-wing flight of birds, bats, and insects. Though machines may differ in form, they are usually built on the same scale as flying animals.

  7. UTIAS Snowbird - Wikipedia

    en.wikipedia.org/wiki/UTIAS_Snowbird

    [1] [4] Take-off was assisted with a tow from a car to get the aircraft up to speed, before flapping for lift-off. [1] A total of 16 flaps were used on the run to maintain height. [ 1 ] At the start of the flight, data indicates that the Snowbird was able to gain height, while maintaining speed, indicating that there was more power than ...

  8. Flapping counter-torque - Wikipedia

    en.wikipedia.org/wiki/Flapping_counter-torque

    Flapping counter-torque is a ubiquitous passive rotational damping effect in flapping flight that arises from world frame differences in the speed of flapping wings during turns. During a turns, flapping that is symmetrical (in velocity and speed) in the body frame of the animal is not symmetrical (in velocity or speed) in the lab frame. During ...

  9. Edward Purkis Frost - Wikipedia

    en.wikipedia.org/wiki/Edward_Purkis_Frost

    Frost began studying flight in 1868 and built a large steam-powered flying machine with both fixed and flapping wings from 1870 to 1877. Frost had intended to have a 20-25 hp steam engine but the actual engine with 5 hp was not powerful enough to lift the ornithopter from the ground. The experiment cost Frost £1000.

  1. Related searches ornithopter flapping wing mount kit harbor freight car lift 120v

    ornithopter flapping wing mount kit harbor freight car lift 120v with 3