Ads
related to: dexter axle to seal chart
Search results
Results From The WOW.Com Content Network
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
Planetary differential used to drive a chart recorder c. 1961. The motors drive the Sun and annular gears, while the output is taken from the planet gear carrier. This gives 3 different speeds depending on which motors are on. Non-automotive uses of differentials include performing analogue arithmetic. Two of the differential's three shafts are ...
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...