When.com Web Search

  1. Ad

    related to: where are motor mounts located on engine parts kit

Search results

  1. Results From The WOW.Com Content Network
  2. Bushing (isolator) - Wikipedia

    en.wikipedia.org/wiki/Bushing_(isolator)

    "The most radical feature of his car was the novel suspension of its six-cylinder engine so as to cut down vibration. The engine was supported on three points and rested on rubber mounts. Noise and vibration were much less. There was still a lot of movement of the engine when idling, but under a load it settled down.

  3. Component parts of internal combustion engines - Wikipedia

    en.wikipedia.org/wiki/Component_parts_of...

    Most piston engines use a starter motor powered by the same battery as runs the rest of the electric systems. Large jet engines and gas turbines are started with a compressed air motor that is geared to one of the engine's driveshafts. Compressed air can be supplied from another engine, a unit on the ground or by the aircraft's APU. Small ...

  4. Bell housing - Wikipedia

    en.wikipedia.org/wiki/Bell_housing

    The starter motor may mount to it, and it may support clutch and/or shifter linkage. [2] A Bellhousing may be a separate housing bolted to the gearbox, or it may be an integral portion of the transmission housing, particularly with front wheel drive transmissions. An integral bell has a front bolt pattern that matches the engine to which it ...

  5. List of auto parts - Wikipedia

    en.wikipedia.org/wiki/List_of_auto_parts

    This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines ) and electric vehicles ; the list is not exhaustive.

  6. Ford Cologne V6 engine - Wikipedia

    en.wikipedia.org/wiki/Ford_Cologne_V6_engine

    The Cologne V6 was designed to be compatible in installation with the Ford Taunus V4 engine, having the same transmission bolt pattern, the same engine mounts, and in many versions, a cylinder head featuring "siamesed" exhaust passages, which reduced the three exhaust outlets down to two on each side. The latter feature was great for ...

  7. Engine block - Wikipedia

    en.wikipedia.org/wiki/Engine_block

    In an internal combustion engine, the engine block is the structure that contains the cylinders and other components. The engine block in an early automotive engine consisted of just the cylinder block, to which a separate crankcase was attached. Modern engine blocks typically have the crankcase integrated with the cylinder block as a single ...

  8. Mitsubishi 4B1 engine - Wikipedia

    en.wikipedia.org/wiki/Mitsubishi_4B1_engine

    The exhaust manifold has a rear location on the transverse engine, compared to the front location for the previous engine, yielding important benefits such as better emissions performance. To lower vibration, Mitsubishi used a 4-point inertial axis system with cylindrical hydraulic engine mounts on the left and right sides. A lightweight, high ...

  9. Shock mount - Wikipedia

    en.wikipedia.org/wiki/Shock_mount

    A shock mount or isolation mount is a mechanical fastener that connects two parts elastically to provide shock and vibration isolation. Isolation mounts allow equipment to be securely mounted to a foundation and/or frame and, at the same time, allow it to float independently from it.