Ads
related to: best cylinder heads for ls1
Search results
Results From The WOW.Com Content Network
The traditional five-bolt pentagonal cylinder head pattern was replaced with a square four-bolt design (much like the 1964–1990 Oldsmobile V8), and the pistons are of the flat-topped variety (in the LS1, LS2, LS3, LS6, LS7, LQ9, and L33), while all other variants, including the new LS9 and LQ4 truck engine, received a dished version of the GM ...
It is Chevrolet's last production first-generation small-block. The cylinder heads feature combustion chambers and intake ports very similar to those of the LT1 V8, but lacking the LT1's reverse-flow cooling and higher compression. As such, the L31 head is compatible with all older small-blocks, and is a very popular upgrade.
All engines have cast iron blocks and cylinder heads. The engines are based on the Chevrolet Small-Block engine , and the V6 is formed by the removal of the #3 and #6 cylinders. The V6s share the same 4.4-inch (110 mm) bore spacing and 9.025-inch (229.2 mm) deck height as the V8 engines .
A redesigned cylinder head and manifold for improved air flow. Variable exhaust valve timing (the LW2 engine only had variable intake valve timing) Specially-developed fuel injectors. New pistons with pentroof-style centre-domes and valve eyelets for a higher compression ratio of 12.2:1 (compared to 10.2:1 for the dual fuel engine).
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
Wards 10 Best Engines is an annual list of the ten "best" automobile engines available in the U.S. market, that are selected by Wards AutoWorld magazine. The list was started in 1994 for model year 1995, and has been drawn every year since then, published at the end of the preceding year.
The addition of two milled cutouts [in the head] to extend the volume of the combustion wedge can create a compression ratio of 7.5:1; one milled cutout produces a 9.5:1 compression ratio. The difference between the volume of these cutouts provides a wide compression range without making any changes in the piston or cylinder head.
A Heron cylinder head, or simply Heron head, is a design for the combustion chambers of the cylinder head on an internal combustion piston engine, named for engine designer S. D. Heron. The head is machined flat, with recesses only for inlet and exhaust valves, spark plugs, injectors and so on.