Search results
Results From The WOW.Com Content Network
Typical POST screen (AMI BIOS) Typical UEFI-compliant BIOS POST screen (Phoenix Technologies BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
A bright dot defect or hot pixel is a group of three sub-pixels (one pixel) all of whose transistors are "off" for TN panels or stuck "on" for MVA and PVA panels. [2] This allows all light to pass through to the RGB layer, creating a bright pixel that is always on.
A checksum of a message is a modular arithmetic sum of message code words of a fixed word length (e.g., byte values). The sum may be negated by means of a ones'-complement operation prior to transmission to detect unintentional all-zero messages. Checksum schemes include parity bits, check digits, and longitudinal redundancy checks.
Some computer designs have used non-button cell batteries, such as the cylindrical "1/2 AA" used in the Power Mac G4 as well as some older IBM PC compatibles, or a 3-cell nickel–cadmium (Ni–Cd) CMOS battery that looks like a "barrel" (common in Amiga and older IBM PC compatibles), which serves the same purpose. These motherboards often have ...
sCMOS sensors tend be more expensive than traditional CMOS sensors. sCMOS sensors have a limited resolution compared to other types of sensors like CCD. [10] Comparison - CCD vs. sCMOS technology; lower figure compares a scientific grade CCD (left) and a pco.edge camera with sCMOS sensor (on the right) under similar weak illumination conditions.
File integrity monitoring (FIM) is an internal control or process that performs the act of validating the integrity of operating system and application software files using a verification method between the current file state and a known, good baseline.
File verification is the process of using an algorithm for verifying the integrity of a computer file, usually by checksum.This can be done by comparing two files bit-by-bit, but requires two copies of the same file, and may miss systematic corruptions which might occur to both files.
A micrograph of the corner of the photosensor array of a webcam digital camera Image sensor (upper left) on the motherboard of a Nikon Coolpix L2 6 MP. The two main types of digital image sensors are the charge-coupled device (CCD) and the active-pixel sensor (CMOS sensor), fabricated in complementary MOS (CMOS) or N-type MOS (NMOS or Live MOS) technologies.