Search results
Results From The WOW.Com Content Network
Translation of assembly language into machine language. A much more human-friendly rendition of machine language, named assembly language, uses mnemonic codes to refer to machine code instructions, rather than using the instructions' numeric values directly, and uses symbolic names to refer to storage locations and sometimes registers. [3]
In computer programming, assembly language (alternatively assembler language [1] or symbolic machine code), [2] [3] [4] often referred to simply as assembly and commonly abbreviated as ASM or asm, is any low-level programming language with a very strong correspondence between the instructions in the language and the architecture's machine code instructions. [5]
The instructions constituting a program are rarely specified using their internal, numeric form (machine code); they may be specified by programmers using an assembly language or, more commonly, may be generated from high-level programming languages by compilers.
Machine code is the form in which code that can be directly executed is stored on a computer. It consists of machine language instructions, stored in memory, that perform operations such as moving values in and out of memory locations, arithmetic and Boolean logic, and testing values and, based on the test, either executing the next instruction in memory or executing an instruction at another ...
Assembly language. Low-level programming language. In computer programming, assembly language (alternatively assembler language [1] or symbolic machine code), [2] [3] [4] often referred to simply as assembly and commonly abbreviated as ASM or asm, is any low-level programming language with a very strong correspondence between the instructions in the language and the architecture's machine code ...
As it is an assembly language, BAL uses the native instruction set of the IBM mainframe architecture on which it runs, System/360.. The successors to BAL use the native instruction sets of the IBM mainframe architectures on which they run, including System/360, System/370, System/370-XA, ESA/370, ESA/390, and z/Architecture.
The Motorola 6800 microprocessor was the first for which an undocumented assembly mnemonic HCF became widely known. The operation codes (opcodes—the portions of the machine language instructions that specify an operation to be performed) hexadecimal 9D and DD were reported and given the unofficial mnemonic HCF in a December 1977 article by Gerry Wheeler in BYTE magazine on undocumented ...
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.