When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Long-bolt engine - Wikipedia

   en.wikipedia.org/wiki/Long-bolt_engine

   A long-bolt or through-bolt engine is an internal combustion piston engine where, following usual practice, the cylinder head is held down by bolts or studs. Conventionally the cylinder head is bolted to the cylinder block and the crankshaft main bearings are in turn bolted to the crankcase by separate bolts. [notes 1] In the long-bolt engine ...

3. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   "Waisted" or "undercut" studs, as engine cylinder head retainers. With respect to shape, stud bolts a.k.a. studs are categorized into three basic types: "fully threaded stud bolts", "tap-end stud bolts", and "double-end stud bolts". Each of these studs have different application.

4. Cylinder head - Wikipedia

   en.wikipedia.org/wiki/Cylinder_head

   In a piston engine, the cylinder head sits above the cylinders, [1] forming the roof of the combustion chamber. In sidevalve engines the head is a simple plate of metal containing the spark plugs and possibly heat dissipation fins .

5. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_bellhousing...

   The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

6. List of Perkins engines - Wikipedia

   en.wikipedia.org/wiki/List_of_Perkins_engines

   Three-cylinder diesel engine. Engine serial is a seven digit number beginning with 1000251. 67,433 engines were produced. Uses a timing chain. none: F3: 1957–08 to 1964-10: Three-cylinder diesel engine. Built for Ford, with Simms injector pump. (Ford supplied all the block and head castings). CB: 3.144: CC: P3.144: 1957–03 to 1969-05

7. BMC B-series engine - Wikipedia

   en.wikipedia.org/wiki/BMC_B-Series_engine

   The two inlet ports in the non-crossflow cylinder head were shared between cylinders 1 + 2 and 3 + 4 and the three exhaust ports between cylinder 1, 2 + 3 and 4. Valve clearance was adjustable by screws and locknuts on the rocker arms. [7] Another unconventional characteristic of the engine is that the bore spacing is not constant between all ...