Search results
Results From The WOW.Com Content Network
This was provided to allow engine braking on downhills or prevent the use of overdrive gears when towing and was typically achieved using positions such as "3", "2", and "1" on the gear selector. An automatic transmission with a manumatic function provides a greater level of control by allowing the driver to request an upshift or downshift at a ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
Cutaway view of a 2007 Toyota AA80E hydraulic automatic Typical gear selector for an automatic transmission. An automatic transmission (sometimes abbreviated AT) is a multi-speed transmission used in motor vehicles that does not require any input from the driver to change forward gears under normal driving conditions.
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [ 51 ] [ 52 ] [ 53 ] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
In the early mass-produced automobiles, the standard transmission design was manual: the combination of gears was selected by the driver through a lever (the gear stick) that displaced gears and gear groups along their axes. Starting in 1939, cars using various types of automatic transmission became available in the US market. These vehicles ...
Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation: In the longitudinal direction, the gearbox is usually designed separately from the final drive (including the differential). The ...