Search results
Results From The WOW.Com Content Network
It was established by Frank E. Wood in 1919 in Pennsylvania. [2] Metal or tinplate toy trucks, cars and airplanes were their specialty. However, they made various other mechanical and lithographed toys as well. [3] [4] The Girard Model Works operated from the early 1920s to 1934, making various metal toys, vehicles and trains.
The older fire-tube boiler design, in which the water surrounds the heat source and gases from combustion pass through tubes within the water space, is typically a much weaker structure and is rarely used for pressures above 2.4 MPa (350 psi). A significant advantage of the watertube boiler is that there is less chance of a catastrophic failure ...
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
The bypass ratio (BPR) of a turbofan engine is the ratio between the mass flow rate of the bypass stream to the mass flow rate entering the core. [1] A 10:1 bypass ratio, for example, means that 10 kg of air passes through the bypass duct for every 1 kg of air passing through the core.
Fluid bearings are bearings in which the load is supported by a thin layer of rapidly moving pressurized liquid or gas between the bearing surfaces. [1] Since there is no contact between the moving parts, there is no sliding friction, allowing fluid bearings to have lower friction, wear and vibration than many other types of bearings.
Hot water dispenser at Lanzhou Bus Station, China, providing free boiling water to make a cup of tea or a bowl of instant noodles. An instant hot water dispenser or boiling water tap is an appliance that dispenses water at about 94 °C (201 °F) (near-boiling). There are hot-only and hot and cool water models, and the water may be filtered as ...
A minimum return water temperature of 130 °F (54 °C) to 150 °F (66 °C) to the boiler, depending on the specific design, is used to avoid condensing water vapor from the flue gas and dissolving CO 2 and SO 2 from the flue gasses forming carbonic and sulfuric acid, a corrosive fluid that damages the heat exchanger. [10]
An example of a water distribution system: a pumping station, a water tower, water mains, fire hydrants, and service lines [1] [2]. A water distribution system is a part of water supply network with components that carry potable water from a centralized treatment plant or wells to consumers to satisfy residential, commercial, industrial and fire fighting requirements.