Search results
Results From The WOW.Com Content Network
The Precast/Prestressed Concrete Institute (PCI) published the double tee load capacity calculation (load tables) for the first time in the PCI Design Handbook in 1971. The load tables use the code to identify double tee span type by using the width in feet, followed by "DT", followed by depth in inches, for example, 4DT14 is for 4-foot (1.2 m ...
CMVs are restricted by gross weight (total weight of vehicle and cargo), and by axle weight (i.e., the weight carried by each tire). The federal weight limits for CMVs are 80,000 pounds (36,000 kg) for gross weight (unless the bridge formula dictates a lower limit), 34,000 pounds (15,000 kg) for a tandem axle, and 20,000 pounds (9,100 kg) for a ...
Dead loads have small load factors, such as 1.2, because weight is mostly known and accounted for, such as structural members, architectural elements and finishes, large pieces of mechanical, electrical and plumbing (MEP) equipment, and for buildings, it's common to include a Super Imposed Dead Load (SIDL) of around 5 pounds per square foot ...
The Military Load Classification (MLC) is a system of standards used by NATO to classify the safe amount of load a surface can withstand. Load-carrying capacity is shown in whole numbers for vehicles, bridges, roads, and routes. Vehicles are classified by weight, type, and effect on routes.
Strength/weight ratio – Construction materials are commonly categorized by their strength to weight ratio—or specific strength, which is the strength of a material divided by its density. These ratios indicate how useful the material is for its weight, which in turn indicates its cost and ease of construction.
In May 1831, the first 500 rails, each 15 feet (4.6 m) long and weighing 36 pounds per yard (17.9 kg/m), reached Philadelphia and were placed in the track, marking the first use of the flanged T rail. Afterwards, the flanged T rail became employed by all railroads in the United States.
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).
The standard rail weight for British railways is now 113 lb/yd (56.1 kg/m). Before the 1990s, most diesel locomotives were built to a maximum axle load of 19 long tons (19.3 tonnes; 21.3 short tons) so the maximum locomotive weight was 76 long tons (77.2 tonnes; 85.1 short tons) for a four-axle locomotive and 114 long tons (115.8 tonnes; 127.7 short tons) for a six-axle one.