Search results
Results From The WOW.Com Content Network
Car hydraulics are equipment installed in an automobile that allows for a dynamic adjustment in height of the vehicle. These suspension modifications are often placed in a lowrider, i.e., a vehicle modified to lower its ground clearance below that of its original design. With these modifications, the body of the car can be raised by remote control.
The main advantages of a pull-rod suspension system on a track-focused race car have to do primarily with the ability to move suspension components closer to the ground, lower the chassis of the vehicle, and lower the centre of gravity to improve efficiency in cornering, body-roll, and high-speed stability. [2] [7]
A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.
A luxury car, taxi, or passenger bus would be described as having soft springs, for the comfort of their passengers or driver. Vehicles with worn-out or damaged springs ride lower to the ground, which reduces the overall amount of compression available to the suspension, and increases the amount of body lean.
During corner entry the front tires, in addition to generating part of the lateral force required to accelerate the car's centre of mass into the turn, also generate a torque about the car's vertical axis that starts the car rotating into the turn. However, the lateral force being generated by the rear tires is acting in the opposite torsional ...
Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...
For premium support please call: 800-290-4726 more ways to reach us
A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.