Search results
Results From The WOW.Com Content Network
In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data. It formally defines signals connecting between a DTE ( data terminal equipment ) such as a computer terminal or PC , and a DCE ( data circuit-terminating equipment or data communication ...
DF-1 / DF1 protocol is an asynchronous byte-oriented protocol that is used to communicate with most Allen Bradley RS-232 interface modules. DF1 protocol consists of link layer and application layer formats. DF1 works over half duplex and full duplex modes of communication.
The physical hardware communications link (physical layer) is not defined by SCPI. [5] While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer ...
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
Serial cables are typically used for RS-232 communication. A serial cable or RS-232 cable is a cable used to transfer information between two devices using a serial communication protocol. The form of connectors depends on the particular serial port used. A cable wired for connecting two DTEs directly is known as a null modem cable.