Ads
related to: high power resistors wire wound dressing procedure
Search results
Results From The WOW.Com Content Network
Ayrton–Perry windings of resistance wire are used to make wirewound RF resistors that are used at high frequencies, where inductance and capacitance are unwanted. The winding is made of two separate wires wound in opposing directions along an insulating form and connected in parallel at the ends.
Manganin wire as we know it was developed by Weston's assistant John Forrest Kelly. [7] In May 1893, Weston received a patent [citation needed] for the material and its use for resistors. While Manganin represented a significant advance in technology -- the material was a conductive metal with constant resistance over a wide range of working ...
For the high power surgical uses during anesthesia the monopolar modality relies on a good electrical contact between a large area of the body (Typically at least the entire back of the patient) and the return electrode or pad (also known as dispersive pad or patient plate). Severe burns (3rd degree) can occur if the contact with the return ...
Bifilar wound toroidal transformer, also known as a common-mode choke. A different type of bifilar coil is used in some relay windings and transformers used for a switched-mode power supply to suppress back-emf. In this case, the two wire coils are closely spaced and wound in parallel but are electrically isolated from each other.
Nichrome, a non-magnetic 80/20 alloy of nickel and chromium, is the most common resistance wire for heating purposes because it has a high resistivity and resistance to oxidation at high temperatures, up to 1,400 °C (2,550 °F). When used as a heating element, resistance wire is usually wound into coils.
An induction coil consists of two coils of insulated wire wound around a common iron core (M). [1] [7] One coil, called the primary winding (P), is made from relatively few (tens or hundreds) turns of coarse wire. [7] The other coil, the secondary winding, (S) typically consists of up to a million turns of fine wire (up to 40 gauge). [8] [1] [7]
Cable dressing ensures that electrical cables used in a telecommunications facility are neatly arranged. Cable ties , cable channels and cable lacing cord are used to accomplish this. High tension cables are often arranged in a trefoil pattern to allow cable cleats to have sufficient strength with the high forces experienced under short circuit ...
During the start-up a typical rotor has 3 poles connected to the slip ring. Each pole is wired in series with a variable power resistor. When the motor reaches full speed the rotor poles are switched to short circuit. During start-up the resistors reduce the field strength at the stator. As a result, the inrush current is reduced. Another ...