Ads
related to: best budget suspension fork 26 hp
Search results
Results From The WOW.Com Content Network
Front suspension 37 mm (1.5 in) air assisted telescopic fork with TRAC anti-dive 41 mm (1.6 in) air assisted telescopic fork with TRAC anti-dive 41 mm (1.6 in) Showa Cartridge telescopic fork 41 mm (1.6 in) Showa Cartridge telescopic fork Travel 140 mm (5.5 in) Rake 27°40' 26° Trail 108 mm (4.3 in) 100 mm (3.9 in) Rear suspension
1968 BMW R60US with conventional telescopic fork Telescopic fork in upside down design, with stanchions at the bottom.. Conventional telescopic forks invariably have a pair of fork tubes, or "stanchions", at the top, clamped to a triple tree (also called a triple clamp or a yoke), and the sliders are at the bottom, attached to the front wheel spindle.
The springer fork is an early type of leading link fork. A springer fork does not have the suspension built into the fork tubes, but instead has it mounted externally, where it may be integrated into the triple clamp. This style of fork may be found on antique motorcycles or choppers, and is available today on Harley-Davidson's Softail Springer.
Most motorcycles today use telescopic forks for the front suspension. The forks can most easily be understood as simply encased long coil springs with hydraulic damping of excess spring energy. They allow the front wheel to react to imperfections in the road while isolating the rest of the motorcycle from that motion. Telescopic forks on a 1969 BMW
WP rear shock unit on a KTM 950 Adventure in 2007. WP Suspension GmbH is a manufacturer of components for motorcycle suspension systems based in Austria. The company was founded in 1977 by Wim Peters in Malden, Netherlands [1] and is amongst the largest manufacturers of suspension components for motorcycles. [2]
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.