Search results
Results From The WOW.Com Content Network
Commercially available optical flowmeters are capable of measuring flow from 0.1 m/s to faster than 100 m/s (1000:1 turn down ratio) and have been demonstrated to be effective for the measurement of flare gases from oil wells and refineries, a contributor to atmospheric pollution. [13]
Examples include a showerhead with flow rate of 1.75 gpm (6.61 lpm) at high water pressure and 1.45 gpm (5.48 lpm) at low pressure, or a showerhead with three pressure compensated flow rates (by non-removable pressure compensator) with options of 0.5, 1.0 and 1.5 gpm (1.9, 3.8, 5.7 lpm).
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
Volumetric flow rate is defined by the limit [3] = ˙ = =, that is, the flow of volume of fluid V through a surface per unit time t.. Since this is only the time derivative of volume, a scalar quantity, the volumetric flow rate is also a scalar quantity.
K-Factors have also previously been calculated and published using the United States customary units of pound per square inch (psi) and gallon per minute (gpm). Within the United States, US measurements are still often used instead of metric.
The relationship between gallons per minute (gpm) and fixture unit is not constant, but varies with the number of fixture units. For example, 1000 FU is equivalent to 220 US gallons per minute (0.014 m 3 /s) while 2000 FU represents only 330 US gallons per minute (0.021 m 3 /s), about 1.5 times the flow rate.
Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions.
The Oil Storage Regulations (2001) apply to oil tanks used for commercial and industrial purposes, or domestic tanks over 3500 litres in capacity. They state that the storage tank should be of "sufficient strength and structural integrity to ensure that it is unlikely to burst or leak in its ordinary use". [12] The tank, along with any filters ...