Ads
related to: sata mode ide or ahci
Search results
Results From The WOW.Com Content Network
When a SATA controller is configured to operate in IDE Mode, the number of storage devices per controller is usually limited to four (two IDE channels, master device and slave device with up to two devices per channel), compared to the maximum of 32 devices/ports when configured in AHCI mode.
It contains two operation modes that follow two Intel specific modes rather than the SATA standard. The name modes and the application that contains them have been renamed since the first version. Until 2010 it contains AHCI and Matrix RAID modes. The first mode is the Intel driver SATA normal and the latter mode is a fake RAID. [1]
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Windows XP can be installed in IDE mode but without SATA features enabled. For users that dual boot Windows XP with another operating system installed in AHCI mode, this means changing to IDE mode every time to boot into Windows XP and changing back to SATA to boot the other OS, or installing the other OS which supports AHCI also in IDE mode to ...
The 40-pin IDE/ATA connection transfers 16 bits of data at a time on the data cable. The data cable was originally 40-conductor, but later higher speed requirements for data transfer to and from the hard drive led to an "ultra DMA" mode, known as UDMA .
Six SATA 3 Gbit/s ports in either legacy IDE or AHCI mode. Can support external eSATA; Intel High Definition Audio; Integrated gigabit LAN; AHCI support; Two EHCI host controllers (which support up to twelve USB 2.0 connections) with companion UHCI controllers to handle low-speed and full-speed USB devices; This part has the following variants:
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
It is confirmed that with native Microsoft drivers the TRIM command works on Windows 7 in AHCI and legacy IDE / ATA Mode. [44] Windows 8 and later Windows operating systems support the unmap command for devices that use the SCSI driver stack, including USB Attached SCSI Protocol (UASP).